Specifications

Jumper Settings and Connectors
Chapter 3
Jumper Settings and Connectors
This chapter will assist you in setting up the SL 486VE before you install it in
a system case. If your SL 486VE has already been installed and you do not
wish to change the configuration settings, you can skip over this section.
3.1 Jumper Settings
The SL 486VE has several jumper switches that must be set to define a system
configuration. They are turned off and on by placing or removing a cover cap
over the pins. This is called an opened or a closed jumper. All jumpers must
be set to one of the possible two settings.
Figure 3.1 shows the location of the jumpers and connectors.
3-1