User`s guide

T-MOPSlcdSA User's Guide
Appendix B: BIOS Operation 48
48
Feature Option Description
Configure Remote Access
Type and Parameters
Remote Access Disabled
Enabled
Disabled/Enabled: Switches remote-access feature off or on.
Serial Port Number (*) COM1
COM2
Sets the serial port used for remote access to COM1 or COM2.
Enable the selected port in the Super I/O Configuration submenu.
Serial Port Mode (*) 115200 8,n,1
57600 8,n,1
19200 8,n,1
Sets serial port mode for remote access to 115200, 57600 or 19200
Baud. 8-bit data, no parity bit, and one stop bit is used.
Flow Control (*) None
Hardware
Software
Select flow control.
None: No flow control used.
Hardware: Hardware handshake used.
Software: Software handshake used.
Redirection after BIOS POST (*) Disabled
Boot Loader
Always (**)
Select redirection after POST.
Disabled: Turns off redirection after POST.
Boot Loader: Turns on redirection during POST and boot loader.
Always: Redirection is always on.
Terminal Type (*) ANSI
VT100
VT-UTF8
Selects target-terminal type.
ANSI, VT100, or VT-UTF8.
VT-UTF8 Combo Key Support
(***)
Disabled
Enabled
Enable/Disable: Switches off or on VT-UTF8
combination-key support for ANSI and VT100 terminals.
Notes:
In the Option column, bold shows default settings.
(*) This is visible only if Remote Access is enabled.
(**) Some operating systems may not work correctly if this is set to always.
(***) This is visible only when Terminal Type is set to ANSI or VT100.
19.4.5 USB Configuration Submenu
Feature Option Description
USB Configuration
Module Version Displays version information about the used USB module.
USB Devices Enabled Displays all attached and configured USB devices.
Legacy USB Support Disabled
Enabled
Auto
Disabled/enabled: switches onboard USB controller legacy support off
or on.
Auto: USB controller is of when no USB devices connected.
USB Mass Storage Device
Configuration(*)
Submenu Opens USB Mass Storage Device Configuration submenu.
Notes:
In the Option column, bold shows default settings.
(*) This is visible only if a Mass Storage Device is connected.