User`s guide

T-MOPSlcdSA User's Guide
Getting Started 7
7
3. Getting Started
The easiest way to get the T-MOPSlcdSA board running is to use a starter kit from Kontron
Embedded Modules GmbH. Take the following steps:
1. Turn off the power supply (part of the starter kit).
2. Connect the power supply to the starter kit baseboard (part of the starter kit).
3. Connect a CRT monitor to the CRT interface by using the corresponding adapter cable.
4. Plug theT-MOPSlcdSA to the PC/104 bus stack on the starter kit baseboard.
5. Make all necessary connections from the T-MOPSlcdSA to the starter kit board. (Cables
come with the starter kit). The starter kit board offers various interfaces on standard
connectors.
6. Plug a keyboard to the starter kit’s keyboard connector.
7. Plug a hard-drive data cable to the T-MOPSlcdSA hard-disk interface. Attach the hard disk
to the connectorat the opposite end of the cable.
8. If necessary, connect the power supply to the hard disk’s power connector.
9. Make sure all your connections have been made correctly.
10. Turn on the power.
11. Enter the BIOS by pressing the <DEL> key during boot-up. Make all changes in the BIOS
setup. See the BIOS chapter of this manual for details.