User manual

Illustra Flex Series 1MP Wireless Cube
7
TABLE 1-1: PICTORIAL INDEX DEFINITION
Index #
Name
Description
1 WIFI antenna Sending/receiving radio signals from computers or other WIFI
facilities for wireless communication
2 MIC Audio IN
3 Infrared LED* Illumination for night vision
4 Lens Fixed lens
5 Speaker Audio OUT (Optional)
6 Default Button  Resetting the unit to factory default (press and hold for 5
seconds)
 This button also has WPS function. Please press this button
around 2 sec then WPS will be connecting.
7 Reset Button Rebooting the system.
8 RJ-45
Ethernet Connector
Wired network connection socket
9 Power Terminal
Inlet for the power adaptor (DC 5V±10%, 1.5A)
10 Unit stand The unit’s body support
11 LED Indicator
Red Light On Wired Network Ready With Networking
Red Light Blinks Wired Network Ready Without Networking
Blue Light On
 Wireless Network Ready With Networking
and AP connection
 When ad hoc of WIFI mode is enabled and
networking, the blue light will turn on.
 WPS ready and connection
Blue Light Blinks
Wireless Network Ready Without Networking and
AP connection
Blue Light Blinks
Rapid
WPS ready without networking
* D/N mode setting is auto. Cube network camera with IR ON will automatically switch to B/W mode when
the illumination is under a certain threshold.
Note
 Once wired networking is unavailable, please press and hold the default Button for 5
seconds to restore the unit to factory default settings so you may reach the unit at its
default IP address for good. Please use Illustra Connect to find the IP address again.
 If you want to use wireless network, you can press and hold Default (WPS) button a few
seconds to connect the network. The LED status will turn blue after WPS successful
connection. Otherwise, the blue light will always blink rapid. When WPS can’t success
connection, please repeat the operation.