Installation Sheet

Page 1 of 4©2020 American Lighting, Inc. REV2101 www.AmericanLighting.com 11775 E. 45th Ave. Denver, CO 80239 Ph: 1-800-880-1180 Fax: [phone]
SLIM FIT FLUSH MOUNT120V
INSTALLATION INSTRUCTIONS
SF9 Series
FIGURE 1
FIGURE 2
SAFETY INFORMATION
• Read all instructions before beginning; Save these instructions for future use.
• To reduce the risk of fire, electric shock, or injury to persons, pay close attention
to this manual and stay within its guidelines when using this product.
• LED Disc light installation requires knowledge of recessed lighting luminaires and
their electrical systems. If not qualified or uncertain, do not attempt installation:
contact a qualified electrician.
• Supply conductors (power wiring) connecting the fixture must be rated for a
minimum of 90°C.
• Do not make or alter any open holes in wiring enclosures, nor in any electrical
components during kit installation.
• Do not alter, relocate, or remove wiring, lamp holders, power supply, or any other
electrical component.
• This fixture is suitable for use in dry, damp, or wet locations.
• Do not use these products in luminaires located where elevated ambient
temperatures exist.
• To avoid electrical shock, do not turn on fixture with missing or damaged lens.
• There are no serviceable parts inside the fixture or LED module.
• This fixture is suitable for use in dimming circuits: TRIAC/CL/ELV
These products may represent a possible shock or
fire hazard if improperly installed or attached in any
way. Products should be installed in accordance
with these instructions, current electrical codes,
and/or the current National Electric Code (NEC).
The electrical rating of this product is 120V AC,
60Hz. The installer must determine whether the
power supply is appropriate at the luminaire prior
to installation. To avoid possible electric shock, be
sure that power source is turned o at fuse box
and/or circuit breaker prior to attempting
installation or servicing of the fixture.
WARNING
WARNING
FIXTURE CONTENTS (SEE FIGURE 1):
Each Slim Fit light includes:
Attached 6” lead wires
Attached Selectable CCT Switch
Mounting Plate
(3) Quick Connectors
(2) Mounting Screws
INSTALLATION:
1. Ensure power is disconnected at the source and any wall switches
are in the “o” position.
2. Ax the mounting plate directly to a standard junction box using the
mounting screws provided. See Figure 1.
3. Connect supply wires to fixture wires, ensuring to match polarity
(ground/green to ground, common/white to white, hot/black to
black) and insulate connections with included wire nuts.
See Figure 1.
4. Use the CCT slider switch on the selectable CCT switch to set the
desired color temperature for the light. See Figure 2.
5. Complete the installation by pushing the fixture into the mounting
plate, making sure the clips align with the receiving portion of the
mounting plate and the attached selectable CCT switch goes
through the center hole of the mounting plate. See Figure 2.
6. For wet location applications, seal the edge of the fixture where it
meets the ceiling surface with waterproof silicone (Not provided).
White Wire
Black Wire
Ground Wire
Mounting
Plate
Selectable
CCT Switch
Use with a pancake or standard depth 4” junction
box only. Required distance between mounting
holes: 3-1/2”.
Do not attempt to alter for other sizes or purposes.
WARNING