Installation Sheet

Page 2 of 4©2021 American Lighting, Inc. REV2114 www.AmericanLighting.com 11775 E. 45th Ave. Denver, CO 80239 Ph: 1-800-880-1180 Fax: [phone]
QUICK DISC LED DISC LIGHT120V
INSTALLATION INSTRUCTIONS
QD4-3CCT and QD6-3CCT Series
FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
FCC WARNING
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment o󰀨 and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet di󰀨erent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Any changes or modications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
5-YEAR LIMITED PRODUCT WARRANTY
This product is warranted to be free from defects in material and workmanship for a period of five (5) years from the date of purchase. Products that prove to be defective during this period
will be either repaired (i.e. replacement of defective electronics, defective parts of the fixture housing, lens, wiring, switching or lamp sockets; excluding the lamp) or replaced, at the discre-
tion of American Lighting, Inc claims for defective products must be submitted to the retail location from which the product was purchased withing the warranty period. Upon submission
of proper return claim documentation and product to American Lighting, Inc by the retailer, American Lighting, Inc reserves the right to inspect the product for misuse or abuse. Claims for
indirect or consequential damages or for product that, in American Lighting, Inc’s opinion has bee misused, will be denied. This is a warranty of product reliability only and not a warranty
of merchantability or fitness for a particular purpose. American Lighting, Inc shall have no liability whatsoever in any event for payment of incidental or consequential damages, including,
without limitations, installation costs and damages for personal injury and property. These products may represent a possible shock or fire hazard if improperly installed or altered in any
way. This warranty applied only to product that has been properly installed in accordance with instruction sheet and current local codes and/or the National Electrical Code. Warranty does
not apply to any product that has been improperly installed or in situation where components have been altered in any way. This warranty: (1) excludes expendable parts including but not
limited to light bulbs, batteries; (2) carries a 2-year finish warranty protecting finish against tarnishing, flaking, and discolorations; (3) shall be void if this lighting fixture is not installed in the
U.S.A.; and (4) does not cover any losses, labor, injuries to persons/property or costs. This warranty does give you specific legal rights and you may have other rights, which vary from state
to state, Be careful, it is recommended that installation be done by a qualified professional; the purchaser has sole responsibility for proper installation in compliance with all state and local
code requirements. Seller’s employees are not qualified to advise you on the use of this Merchandise. Any oral representation(s) made will not be binding on seller or its employees. The
rights under this limited warranty are to the original purchaser of the Merchandise and may not be transferred to any subsequent owner. This limited warranty is in lieu of all warranties,
expressed or implied including warranties or merchantability and fitness for a particular purpose. Seller shall not be liable for any special, incidental, or consequential damages. The sold
exclusive remedy against the seller will be for the replacement of any defects as provided herein, as long as the seller is willing or able to replace this product or is willing to refund the
purchase price as provided above.
For questions/comments, technical assistance, or repair parts - Please call toll free at 1-800-285-8051 (M-F 8am-5pm), CST)
CARE AND MAINTENANCE:
1. Use only a mild soap and water with soft cloth to clean the fixture. Harsh chemicals will damage the finish. Do not wipe the fixture with a
rough cloth that may scratch the finish or the lens.
EVERFINE GONIOPHOTOMETERS SYSTEM TEST REPORT Page 1 Of 10
LUMINAIRE PHOTOMETRIC TEST REPORT
NAME:
SPEC.:
MFR.: LiBo
TYPE:
DIM.:
SUR.:
WEIGHT:
SERIAL No.:
Shielding Angle:
Test:U:120.39V I:0.1247A P:14.932W PF:0.9950 Freq:59.98Hz Lamp Flux:984.33x1 lm
0
30
60
90
120
150
-/+180
-150
-120
-90
-60
-30
UNIT:cd
C0/180,115.0
UNIT:cd
C30/210,115.0
UNIT:cd
C60/240,114.9
UNIT:cd
C90/270,114.9
AVERAGE BEAM ANGLE(50%):114.9 DEG
0
70
140
210
280
350
LUMINOUS INTENSITY DISTRIBUTION DIAGRAM
C0 PLANE ISOLUX DIAGRAM (UNIT:lx)
MH(m)
2
3
4
5
6
7
8
9
10
11
12
0.0 4.0 8.0
S(m)
48.0
40.0
32.0
24.0
16.0
8.00
6.40
4.00
3.20
2.40
DATA OF LAMP PHOTOMETRIC DATA Eff: 65.92 lm/W
MODEL
NOMINAL POWER(W)
RATED VOLTAGE(V)
NOMINAL FLUX(lm)
LAMPS INSIDE
TEST VOLTAGE(V)
Imax(cd)
LOR(%)
TOTAL FLUX(lm)
CIE CLASS
up(%)
down(%)
η
η
S/MH(C0/180)
S/MH(C90/270)
UP,DN(C0-180)
UP,DN(C180-360)
CIBSE SHR NOM
CIBSE SHR MAX
η
η
DL-6-15DCS
15
120
984.33
1
120
320.5
100.0
984.33
DIRECT
2.1
97.9
1.27
1.26
1.1,49.4
1.0,48.5
1.25
1.35
C Range: 0 - 360DEG
C Interval: 15.0DEG
Range: 0 - 180DEG
Interval: 1.0DEG
γ
γ
Test Speed: HIGH Test System:EVERFINE GO-SPEX500_V1 SYSTEM V2.0.402
Temperature:25.3DEG Humidity:65.0%
Test Distance:3.010m [K=1.0000]Operators:Jack
Test Date:08 July 2019 Remarks:
EVERFINE GONIOPHOTOMETERS SYSTEM TEST REPORT Page 1 Of 10
LUMINAIRE PHOTOMETRIC TEST REPORT
NAME:
SPEC.:
MFR.: LiBo
TYPE:
DIM.:
SUR.:
WEIGHT:
SERIAL No.:
Shielding Angle:
Test:U:120.44V I:0.0726A P:8.6873W PF:0.9934 Freq:59.98Hz Lamp Flux:564.562x1 lm
0
30
60
90
120
150
-/+180
-150
-120
-90
-60
-30
UNIT:cd
C0/180,115.5
UNIT:cd
C30/210,115.5
UNIT:cd
C60/240,115.5
UNIT:cd
C90/270,115.5
AVERAGE BEAM ANGLE(50%):115.5 DEG
0
40
80
120
160
200
LUMINOUS INTENSITY DISTRIBUTION DIAGRAM
C0 PLANE ISOLUX DIAGRAM (UNIT:lx)
MH(m)
2
3
4
5
6
7
8
9
10
11
12
0.0 4.0 8.0
S(m)
27.0
23.0
18.0
14.0
9.10
4.60
3.60
2.30
1.80
1.40
DATA OF LAMP PHOTOMETRIC DATA Eff: 65.24 lm/W
MODEL
NOMINAL POWER(W)
RATED VOLTAGE(V)
NOMINAL FLUX(lm)
LAMPS INSIDE
TEST VOLTAGE(V)
Imax(cd)
LOR(%)
TOTAL FLUX(lm)
CIE CLASS
up(%)
down(%)
η
η
S/MH(C0/180)
S/MH(C90/270)
UP,DN(C0-180)
UP,DN(C180-360)
CIBSE SHR NOM
CIBSE SHR MAX
η
η
DL-4-9DCS
9
120
564.562
1
120
182.3
100.4
566.78
DIRECT
2.2
98.2
1.26
1.27
1.1,49.0
1.1,49.2
1.25
1.35
C Range: 0 - 360DEG
C Interval: 15.0DEG
Range: 0 - 180DEG
Interval: 1.0DEG
γ
γ
Test Speed: HIGH Test System:EVERFINE GO-SPEX500_V1 SYSTEM V2.0.402
Temperature:25.3DEG Humidity:65.0%
Test Distance:3.010m [K=1.0000]Operators:Jack
Test Date:09 July 2019 Remarks:
PHOTOMETRIC DISTRIBUTION SHOWING INTENSITY (Candelas):
QD6 QD4