Installation Sheet

Page 1 of 4©2020 American Lighting, Inc. REV2020 www.AmericanLighting.com 11775 E. 45th Ave. Denver, CO 80239 Ph: 1-800-880-1180 Fax: [phone]
QUICK DISC PIR LED DISC LIGHT120V
INSTALLATION INSTRUCTIONS
QD4PIR and QD6PIR Series
FIGURE 1
SAFETY INFORMATION
• Read all instructions before beginning; Save these instructions for future use.
• To reduce the risk of fire, electric shock, or injury to persons, pay close attention
to this manual and stay within its guidelines when using this product.
• LED Disc light installation requires knowledge of recessed lighting luminaires and
their electrical systems. If not qualified or uncertain, do not attempt installation:
contact a qualified electrician.
• Supply conductors (power wiring) connecting the fixture must be rated for a
minimum of 90°C.
• Do not make or alter any open holes in wiring enclosures, nor in any electrical
components during kit installation.
• Do not alter, relocate, or remove wiring, lamp holders, power supply, or any other
electrical component.
• This fixture is suitable for use in dry, damp, or wet locations.
• Do not use these products in luminaires located where elevated ambient
temperatures exist.
• To avoid electrical shock, do not turn on fixture with missing or damaged lens.
• There are no serviceable parts inside the fixture or LED module.
• Use only a mild soap and water with soft cloth to clean the fixture. Harsh chemicals
will damage the finish. Do not wipe the fixture with a rough cloth that may scratch
the finish or lens.
These products may represent a possible shock or
fire hazard if improperly installed or attached in any
way. Products should be installed in accordance
with these instructions, current electrical codes,
and/or the current National Electric Code (NEC).
The electrical rating of this product is 120V AC,
60Hz. The installer must determine whether the
power supply is appropriate at the luminaire prior
to installation. To avoid possible electric shock, be
sure that power source is turned o at fuse box
and/or circuit breaker prior to attempting
installation or servicing of the fixture.
Use with a pancake or standard depth 4” junction
box only. Required distance between mounting
holes:
QD4: 3-1/2”, QD6: 3-1/2”.
Do not attempt to alter for other sizes or purposes.
WARNING
WARNING
WARNING
FIXTURE CONTENTS (SEE FIGURE 1):
Each Quick Disc light includes:
Attached 6” lead wires
Attached PIR Motion Sensor
(3) Quick Connectors
(2) Mounting Screws
INSTALLATION:
1. Ensure power is disconnected at the source and any wall switches
are in the “o” position.
2. Connect supply wires to fixture wires, ensuring to match polarity
(ground/green to ground, common/white to white, hot/black to
black) and insulate connections with included wire nuts.
3. Twist the lens counter-clockwise to open the fixture.
4. Raise the fixture up to the junction box so that the fixture screw
holes line up with the screw holes on the junction box.
5. Use screws included with fixture to ax the fixture to
the junction box. Tighten screws to firmly hold the fixture
in place.
6. Replace the lens by pressing against the fixture and twisting
clockwise.
7. For wet location applications, seal the edge of the disc where it
meets the ceiling surface with waterproof silicone (Not provided).
Lights turn ON automatically when motion is detected and OFF after 30 sec-
onds when no motion is detected,
Lens
Junction
Box
Ceiling
Quick
Disc
Mounting
Screws
Mounting
Holes
Sensor Detection
Range