Instruction Guide
FIGURE 2
EXTENDING HYBRID 2 KITS (See Figure 1):
Note: When connecting multiple Hybrid 2 Kits together, do not exceed
the maximum run length as noted by the tag on the cord: 150ft max
1. Turn the plastic end cap counter-clockwise to remove from
the first kit.
2. Remove power cord from the second kit.
3. Connect the kits by plugging the male and female halves into each
other, then tightenint the screw-on connection cover.
4. Repeat steps 1, 2, and 3 for any additional kits.
5. Turn the plastic end cap clockwise until it is firmly tightened and
secured on the end of the last kit.
TO REPLACE FUSE:
This plug contains an electrical fuse as a safety feature.
1. Disconnect power before replacing the fuse.
2. Grasp plug and remove from the receptacle or other outlet device.
3. Do not unplug by pulling on the cord.
4. Slide open the fuse access cover (See figure 2).
5. Remove old fuse carefully.
6. Never attempt to replace the fuse with a higher wattage fuse. Use
only 8Amp 125Volt fuse. Failure to do so may be a fire hazard. (One
spare fuse is included; stored inside plug for convenience)
7. Set new fuse in holder and close fuse access cover.
CARE AND MAINTENANCE:
1. For cleaning, use a soft, dry or damp cloth. Do not use harsh chemicals or abrasives.
DO NOT TWIST, HANG VERTICALLY, SUSPEND UNSUPPORTED IN THE MIDDLE, OR BEND ALONG SHORT SIDE
Page 2 of 2©2016 American Lighting, Inc. REV1645 www.AmericanLighting.com 11775 E. 45th Ave. Denver, CO 80239 Ph: 1-800-880-1180 Fax: 303-695-7633
FIGURE 1
MOUNTING WITH MOUNTING CLIPS:
(Plastic mounting clips included
1. Attach mounting clips provided using nails or screws. Be sure that the mounting surface is mechanically sound.
2. Mounting clips should be evenly spaced and be a maximum of 12 inches apart.
3. Make sure that the distance between two separate/nearby lines of Hybrid 2 Kits are at least 1/2” apart to ensure heat distribution.
MOUNTING WITH TRACK OR CHANNEL:
(H2-TRACK-3 or H2-CHAN-3 sold separately)
1. Using appropriate fasteners, attach mounting track/channel to a mechanically sound surface.
2. Gently press Hybrid 2 Kit onto track/channel so that it snaps into place and the Hybrid 2 does not move.
HYBRID 2 Kits120V
INSTALLATION INSTRUCTIONS
H2-KIT Series
Fuse is inside plug.
Slide open fuse access cover as shown.