JK FRONT BUMPER TOW LOOPS Installation Guide – AEV30110AA (Updated 01/29/10) Page 1 of 5
PLEASE READ BEFORE YOU START IN ORDER TO INSTALL THIS PART PROPERLY YOU OR YOUR INSTALLER MUST READ THESE INSTRUCTIONS THOROUGHLY BEFORE BEGINNING THE INSTALLATION. FAILURE TO DO SO MAY RESULT IN MISTAKES AND AFFECT THE QUALITY OF THE FINISHED PRODUCT.
INSTALLATION NOTE: If you have purchased the Premium Front Bumper or the Tow Loops along with the Standard / MILSPEC Front Bumper please follow the instructions provided with the Front Bumper for installation. If you have purchased the Tow Loops after the Standard / MILSPEC Front Bumper has already been installed please use these instructions for installation 1. Remove the Closeout Brackets from the back of the bumper and sides of the frame 2. Temporarily attach the Tow Loop Brackets to the vehicle frame.
8. Install the Closeout Brackets to the Tow Loops using 1/2” x 1 1/2" hex head bolts with washers and nut plate. Leave loose so there is some adjustment to align with the bumper 9. NOTE: The top side bolts are currently 1/2" x 1”. They need to be replaced with a 1/2" x 1 1/2" bolts to account for the added thickness of the Tow Loop Brackets 10. Attach the Closeout Brackets to the backside of the bumper with 3/8” hex head bolts, washers, and flange nuts.
COMMENTS OR QUESTIONS? Be sure to visit our forum at: http://forum.aev-conversions.com American Expedition Vehicles Phone: 406.251.2100 Email: tech@aev-conversions.com Website: http://www.aev-conversions.
