Owner`s manual

4
INLET / OUTLET PLUMBING OPTIONS
 ALWAYS INSTALL either an EcoWater Systems
bypass valve #7214383, or a 3-valve bypass system.
Bypass valves allow you to turn off water to the sof-
tener for repairs if needed, but still have water in
house pipes.
OTHER REQUIREMENTS
 A drain is needed for recharge discharge water. A
floor drain is preferred, close to the EcoWater
Systems conditioner. A laundry tub, standpipe, etc.,
are other options (See Figure 2).
 A 120V, 60 Hz, grounded, continuously “live” electri-
cal outlet is needed, in a dry location within 10 feet of
the EcoWater Systems conditioner.
NOTE: The Commonwealth of Massachusetts plumbing
code 248-CMR shall be adhered to. A licensed plumber
shall be used for this installation.
STANDPIPE
1-- 1/2”
airgap
drain
hose
1-- 1/2”
airgap
drain
hose
LAUNDRY TUB
DRAIN OPTIONS
floor drain
valve drain hose
brine
tank
overflow
hose
TWO--TANK
MODEL
1-- 1/2”
airgap
INLET
OUTLET
3-- valve
bypass system
inlet valve
outlet valve
bypass valve
floor drain
NOTE: Faceplate and support
not shown for clarity of drawing.
Tie or wire valve drain hose in place
to keep over floor drain.
brine tank
overflow hose
valve drain hose
CABINET
MODEL
1-- 1/2”
airgap
120V, 60Hz
outlet
transformer
(supplied)
to
controller
INLET
OUTLET
HARD
WATER
HARD
WATER
CONDITIONED
WATER
bypass valve
#7214383
to
controller
FIG. 1
TYPICAL INSTALLATION DRAWINGS
FIG. 2
ECOWATER
SYSTEMS
Planning Installation