User`s guide

User’s Guide
30 Advanced Setup Using On-Screen Menus
Camera Auto-Detect
The multiplexer can check the camera inputs for a video signal to determine whether
a functioning camera is connected or not. Auto detection avoids wasting VCR
recording bandwidth on undetected cameras. To use the auto detection function,
move the cursor to 2 Camera Auto-Detect, and press Enter. A table will appear, with
undetected cameras marked with a dot symbol in the corresponding position.
Camera Title
Camera titles can be turned on or off by configuring the OSD, or on-screen display
(see OSD on page 26). The default title for each camera is 1-16. This menu allows you
to enter a custom title (up to 12 characters) for each camera. In the Camera Set Up
Menu, move the cursor to 3 Camera Title and press Enter. The following list of
cameras will appear:
Alarm Rec Priority Used to set the recording priority when an alarm is
triggered for the current channel, either by an Alarm In
or by Motion Detection. This value should be set above
the Rec Priority value for the channel if increased
recording detail is desired during an alarm.
Call Monitor Sequence There are 16 slots in the Call Monitor sequence. One
camera can be displayed in each slot, in sequence from
left (column 1) to right (column 16) in the row. Enter a
digit in each slot to customize the sequence: 0=jump to
next column, 1=channel 1, 2=channel 2, … 16=channel
16.
PARAMETER DESCRIPTION
Camera Title
1 Camera_1 10 Camera_10
2 Camera_2 11 Camera_11
3 Camera_3 12 Camera_12
4 Camera_4 13 Camera_13
5 Camera_5 14 Camera_14
6 Camera_6 15 Camera_15
7 Camera_7 16 Camera_16
8 Camera_8 17 Exit
9 Camera_9