User`s guide

System Installation 7

SYSTEM INSTALLATION

WARNING: TURN POWER OFF BEFORE MAKING CONNECTIONS.

BASIC CONNECTIONS

A. Connect the video signal from each camera to one of the video input BNC

connectors marked Video IN.

B. Connect the Main Monitor to the Main Monitor output of the unit (either BNC or

S-VHS connector).

C. Connect the DC 12V/1.5Amp adapter to the DC jack at the lower right of the rear

panel.

OPTIONAL CONNECTIONS

Single VCR:

Connect the input of the VCR to the VCR Output BNC or S-VHS connector (D), and

the output of the VCR to the VCR Input BNC or S-VHS connector (E). This will allow

previously recorded video to be replayed through the multiplexer, but not while

simultaneously recording live video.

Two VCRs:

Connect the input of the VCR to be used for recording to the VCR Output BNC or S-

VHS connector.

Figure 3 — Rear Panel

Gray indicates connectors/controls not available on 10-Channel models