Specifications

SpeedDome Ultra III Camera Dome
8000-2573-01, Rev. B
INSTALLATION AND SERVICE GUIDE 27
Removing the Tilt Motor
1. Perform procedure “Removing the Slot
Covers” (page 24).
2. Perform procedure “Removing the Camera”
(page 25).
3. Perform procedure “Detaching the Eyeball”
(page 25).
4. Separate yoke brackets (Figure 33).
Figure 33. Separating the yoke brackets
5. Gently pry off yoke bracket covering pan
gear assembly to access tilt cable assembly
(Figure 34).
Figure 34. Removing the yoke brackets
6. Access tilt motor.
To do this, loosen captive retaining screw
holding tilt cable assembly in place and gently
remove this assembly.
7. Remove tilt motor (Figure 35).
Lift motor housing up as shown (1) to
disengage motor from tilt gear. Then pull motor
bracket towards outside of cable/tilt assembly
(2) to remove motor.
Figure 35. Removing the tilt motor
8. Reverse steps to reassemble.
CAUTION:
When installing a new motor, be
careful to properly mesh motor and tilt gears!
Failure to do so can destroy both motor and tilt
gear. Verify tilt gear turns freely!
Tilt Motor
(Lift up, then out.)