Specifications

24 INSTALLATION AND SERVICE GUIDE
SpeedDome Ultra III Camera Dom
e
8000-2573-01, REV.
B
Removing the Pan Motor
Referring to Figure 24.
1. Perform procedure “Removing the CPU
Board” (page 23).
2. Perform procedure “Removing the P/S
Board” (page 23).
3. Remove pan motor.
Lift motor housing up as shown (1) to disen-
gage motor from pan gear. Then pull motor
bracket towards outside of housing (2) to
remove.
4. Reverse steps to reassemble.
CAUTION:
When putting in a new motor, be
careful to properly mesh motor and pan gears!
Failure to do so can destroy both motor and pan
gear. Verify pan gear turns freely!
Figure 24. Removing the pan motor
1
2
Removing the Slot Covers
1. Gently swivel eyeball to totally expose one
of two slot covers (Figure 25).
CAUTION:
Swiveling fast can damage gears.
2. Insert small, thin-bladed screwdriver into
space between cover and eyeball.
3. Gently pry off slot cover.
4. Gently swivel eyeball to totally expose
remaining slot cover.
With other cover removed, this cover can be
easily removed.
Figure 25. Removing slot covers
Pan Motor
(lift up,
then out)