Specifications

SpeedDome Ultra III Camera Dome
8000-2573-01, Rev. B
INSTALLATION AND SERVICE GUIDE 11
Connecting the Dome to a
Base Mounted Indoors
This section explains how to connect the housing
and eyeball assembly indoors to:
•
A standard base
•
A base with I/O board.
Read “Before You Begin” before beginning these
procedures.
Before You Begin
This section explains what you must do to ensure
a smooth and successful installation, and lists
software, tools, and parts that should be on-site.
You must:
❏
Have electrical work comply with latest national
electrical code, national fire code, and all
applicable local codes and ordinances.
❏
Coordinate work with other trades to avoid
interference.
❏
Verify existing site conditions and coordinate
with the owner’s representative and appropriate
utilities as required.
❏
Obtain copies of all related plans, specifi-
cations, shop drawings and addenda to
schedule and coordinate related work.
❏
Thoroughly review the project to ensure that all
work meets or exceeds the above require-
ments. Bring alleged discrepancies to the
attention of the CCTV Project Coordinator.
Items You Will Need
You should have on hand the following software,
tools, and parts:
❏
Dome software (latest version)
❏
Install/Removal tool to attach and detach
domes and bubbles without a ladder (only if
using a base with I/O board).
❏
If a mounting base is used, base kit:
−
0351-1628-01 (base with I/O board), or
−
0351-1629-01 (standard base).
❏
Housing and eyeball assembly, 0100-2283-XX.
The -XX determines the type of camera used.
-01 = Color NTSC
-02 = Color PAL
-03 = Black and White EIA
-04 = Black and White CCIR