Specifications

SPEEDDOME ULTRA VI 8000-2830-03, REV. C
INSTALLATION AND SERVICE GUIDE 30 of 34
Illustrated Parts List
This section helps you to identify parts that make
up the base and housing and eyeball assembly.
Parts in Table 3 are shown in Figure 37.
Note: Not all of the parts, which are shown for
clarity, are orderable. Parts are subject to change
based on design improvements and availability.
Table 3. Parts list
1 Mounting Base 0400-1146-01/-02
2
Video Cable Adapter,
BNC to Micro
6003-0131-01
3 Plug, 4-Pin 2109-0572-04
4 Plug, 9-Pin 2109-0572-09
5 Lanyard 0500-8019-01
6 Screw, PH, M3 (Qty. 6) 5801-1051-120
7 Washer, Ext. Tooth, M3 5851-0200-041
8 Clip, Lanyard 0500-8046-01
9 Mounting Base 0500-7257-02/-03
10 Ground Clip 0500-7293-01
11 I/O Board 0301-0546-01
12 Dust Cover 3100-0066-01
13
Screws, M3x8 PHP
(Qty. 3)
5801-1071-111
14 Cap 0500-8021-02/-03
15 CPU PC Board 0301-1548-01
16 Fan Cable Assy. 0650-2001-01
17
Standoff, M3x8Hx13L
(Qty. 3)
5899-0055-01
18 Fan Plate 0500-9850-01
19
Screw, Thdcut, M3.5
(Qty. 2)
5899-0008-01
20
Standoff, M3x6Hx19L
(Qty. 3)
5887-1122-020
21 Power Supply PC Board 5606-0015-01
22 Slip Ring Assy. 2100-0005-01
23 Pan Motor 3501-0017-01
24 Housing 0500-7255-02/-03
25
Bearing Assy., Pan
Gear
2510-0040-01
26 Skirt 0500-6710-01
27 Tilt Motor 3501-0018-01
28 Slot Cover (No Lens)* 0500-8037-01/-02
29 Yoke, Camera 0500-7258-01
30 Camera/Lens PC Board 0301-0953-01
31
Bearing Assy., Lens
Carriage
2510-0038-01
32 Yoke Bracket (Qty. 2) 0500-8038-01/-02
33 Cable Assy., Tilt 0650-1680-01
34 Camera, 23x, NTSC 2003-0046-01
35 Camera, 23x, PAL 2003-0046-02
36 Washer, Flat 2848-8100-08
37 Screw, 1/4-20 x 3/8 2802-7407-65
38 Screws, M2x3 (Qty. 4) 5801-0011-120
39 Tripod Mount 0500-6712-01
40 Slot Cover with Lens* 0400-1178-01/-02
* Items 28 and 40 are supplied with the final assembly,
not the eyeball assembly.