Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. B
OPERATOR’S GUIDE
62 of 140
Note: If you change the parameters in the Camera Functions menu for an
existing Preset, you will need to reprogram the Preset to save the changes.
Follow the steps below to change camera functions with Presets:
1. Access the Dome Configuration Menu (
Figure 50) by pressing Iris Open, Focus Far,
and Zoom Out on your controller.
Figure 50. Dome Configuration Menu screen
2. Highlight Alarms / Areas / Home / Presets / PZ and press Focus Far to select. The
Alarms / Areas / Home / Presets / PZ screen appears.
Figure 51. Alarms/Areas/Home/Presets/PZ screen
ALARMS/AREAS/HOME/PRESETS/PZ
SET ALARM ACTIONS
SET ALARM STATES
SET HOME POSITION
SET NORTH POSITION
AREA BOUNDARIES
PRIVACY ZONES
PRESETS
SCAN LIMITS
EXIT
DOME CONFIGURATION MENU
PAN/TILT/ZOOM/SYNC OPTS
CAMERA FUNCTIONS
ALARMS/AREAS/HOME/PRESETS/PZ
ON-SCREEN TEXT DISPLAY
LANGUAGE / PASSWORD
DOME INFORMATION
RESET TO FACTORY SETTINGS
QUIT WITHOUT SAVING
EXIT AND SAVE CHANGES