Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. B
OPERATOR’S GUIDE
44 of 140
Figure 31. Set Home Position screen
Tip: When a pattern is selected as the home position, the pattern runs until stopped
manually by issuing a camera command, such as Tilt or Focus.
Setting the Home Position
1. Select Alarms/Areas/Home/Presets/PZ from the Dome Configuration Menu.
2. Select Set Home Position.
The highlight bar appears on the Home Position setting.
3. Select a setting.
• Select from the following home positions: Preset, Pattern, Output, Sequence,
Random Scan, Stepped Scan, or Smooth Scan.
• Select No Action if you do not want to set a home position. Continue with step 5.
The default setting is No Action.
4. Move the highlight bar to the Number field, and select a number.
• For preset, select the number from 1 through 96. Continue with step 5.
Note: The protocol used may support fewer presets. Refer to the
appropriate Appendix for additional information.
• For pattern, select the number from 1 through 3 for the pattern you want to assign.
Continue with step 5.
If the selected pattern is not programmed, the dome runs the Apple Peel pattern.
• For output, select the number from 1 through 3 for the output you want to assign.
Continue with step 5.
SET HOME POSITION
ACTION PRESET 1
RETURN TIME MINS 10
EXIT