Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. B
OPERATOR’S GUIDE
28 of 140
•
To change settings, move the highlight bar to the appropriate field and make the desired
changes.
• To change the settings for this screen to the factory defaults, select Reset to Factory
Settings.
• To return to the Dome Configuration Menu, select Exit.
Adjusting White Balance Settings
White balance is normally compensated for by the automatic white balance gain control. In
some lighting conditions, you may need to manually adjust the red and blue settings for
optimal viewing.
When Automatic White Balance is enabled, the red and blue setting values are based on
feedback from the camera. When Automatic White Balance is disabled, the camera uses the
red and blue setting values to control the white balance. When Automatic White Balance is
first switched from On to Off, the red and blue values displayed are based on the current
feedback from the camera. The red and blue values range from 0 to 511. Changes occur in
increments of 5.
The following chart illustrates the red and blue settings relationship to white balance.
Figure 19. White Balance color relationships
As the value for the red setting increases, the image appears more red. As the value decreases,
the image appears less red.
Maximum
Blue
Minimum
Blue
Minimum
Red
Maximum
Red
On-screen Color
appears Green
On-screen Colo
r
appears Ma
g
enta
(Purple)
Both Red and
Blue settings
are maximized.
WHITE BALANCE
511
511
0
0