Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. B
OPERATOR’S GUIDE
111 of 140
Appendix D: Panasonic Up-the-Coax (UTC) Protocol Command
Summary
This appendix summarizes the SpeedDome Ultra 8 camera dome features that are supported by
the Panasonic UTC protocol. In addition, it provides the controller commands used with the
Configuration Utility. It also provides information about tested Panasonic equipment.
Supported SpeedDome Ultra 8 Camera Dome Features
With the following exceptions, the SpeedDome Ultra 8 camera dome supports the feature set
described in this operator’s guide when controlled with the Panasonic UTC (Up-the-Coax)
protocol.
Unsupported SpeedDome Ultra 8 Camera Dome Features
• Panasonic controllers that do not support as many presets or outputs as the SpeedDome
Ultra 8 camera dome are limited to the maximum quantities they are designed to support.
• Saving and exiting from configuration menus using Iris Close and Focus keys
• Patterns
• V-Phase adjustment
• PAL video format. This will be supported after further testing.
• Long line length applications that require video amplifiers or fiber optics
Panasonic UTC Command Summary
The following table lists the commands to operate the configuration utility when the dome is
installed in a Panasonic UTC environment.
If you want to … Use …
Start the configuration utility.
Camera Set ON
Set Up/Esc + Camera
Move the highlight bar on the active menu.
Up/Down
Select the highlighted item on the active menu.
SET
Increase the value of the selected setting. For example, Red or
Blue white balance values.
Right
Decrease the value of the selected field. For example, Red or
Blue white balance values.
Left
Display the next choice for the setting. For example,
Maximum Zoom setting.
Right
Display the previous choice for the setting. For example,
Maximum Zoom setting.
Left
Adjust dome position during menu programming.
ALT