Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. C
OPERATOR’S GUIDE
95 of 138
Figure 88. Dome Address Changed screen
Do one of the following:
• If you want to update the dome data from the base memory, highlight Update
Dome Data from Base, and then press FOCUS FAR. A screen briefly appears
that indicates the base memory is being updated (
Figure 89).
Note: Update Dome Data From Base should only be used when
swapping identical dome models.
Figure 89. Restoring Dome Data screen
• If you want to clear the base data, highlight Clear Base Data, and then press
FOCUS FAR. The configuration data is then loaded into the base from the dome.
Any user-programmed data in the base remains in the base IO memory. A screen
appears that indicates the base data is being cleared (
Figure 90).
Restoring Dome Data
Names Buffer
TPB Buffer
DOME ADDRESS CHANGED!!
UPDATE DOME DATA FROM BASE
CLEAR BASE DATA