Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. C
OPERATOR’S GUIDE
85 of 138
Figure 75. Set Password screen
3. Move the blinking highlight around the available characters. When the correct character is
highlighted, press Focus Far.
If you make a mistake, press Zoom In to move the cursor one space right or Zoom Out
to move the cursor one space left.
4. Repeat step 3 until the password is complete. When finished, select Continue.
5. You must successfully enter the password twice. Use the procedure in step 3 to enter the
password again. When finished, select Continue.
Note: If the passwords do not match, you must start over. Return to step 3 and
repeat the procedure.
6. The Language/Password screen appears. Select Exit. The Dome Configuration Menu
appears.
Enabling or Disabling Password Protection
Password protection must be enabled before passwords can be used. To enable or disable the
dome password:
1. Select Language/Password from the Dome Configuration Menu.
2. Move the highlight bar to Password Protection.
3. Change the setting.
• Select ON to enable password protection.
• Select OFF to disable password protection.
The default setting is OFF.
4. Select Exit. The Dome Configuration Menu appears.
Tip: Instructions for entering the dome password are found in Chapter 1.
SET PASSWORD
PASSWORD: ********
ABCDEFGHIJKLMNOPQRST
UVWXYZabcdefghijklmn
opqrstuvwxyz 0123456
789/-
CONTINUE
CANCEL
Blank Space
character