Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. C
OPERATOR’S GUIDE
69 of 138
Additional Dome Commands
Table 9 provides the special commands available when using the dome in an AD-UTC
network. These commands are available when you enter the keyboard combination provided.
Table 9. Additional dome commands
Command Function
F
(Function), Preset #
(1-96), and then (Preset)
Program selected Preset
Preset # (1-96), and then
(Preset)
Recall selected Preset
F
(Function), pattern # (1-3),
and then
+
(Shift+Preset)
(Ver. 0.20 keyboard only) Start selected Pattern programming
Pattern # (1-3), and then
F
(Function)
(Ver. 0.20 keyboard only) Save Pattern programming
Pattern # (1-3), and then
+ (Shift and Preset)
(Ver. 0.20 keyboard only) Run selected Pattern continuously
F
(Function), pattern #
(1-3), then
(Pattern),
move joystick as desired, enter
Pattern number, and then
F
(Function)
(Ver. 1.0 keyboard only) Program a Pattern in RS-485 mode
F
(Function), pattern #
(1-3), then
(Pattern), and
then
F
(Function)
(Ver. 1.0 keyboard only) Delete a Pattern in RS-485 mode
F
(Function), pattern #
(1-3), then (Pattern),
move joystick as desired, and
then
(Pattern)
(Ver. 1.0 keyboard only) Program a Pattern in RS-232 mode
F
(Function), pattern #
(1-3), then
(Pattern), and
then
(Pattern)
(Ver. 1.0 keyboard only) Delete a Pattern in RS-232 mode
F
+ (Function+Focus
Far)
Or
F
+ (Function+Focus
Near)
Resume Auto Focus mode
F
+
(Function+Iris Open)
Or
F
+
(Function+Iris Close)
Resume Auto Iris mode
(Flip)
Rotate dome 180° from current position (“flip”)