Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. C
OPERATOR’S GUIDE
62 of 138
Note: Zone sensitivity ranges from zero (no sensitivity) to five (high
sensitivity). Zero is used to disable individual zones on a temporary basis.
9. Highlight the Action field. Press the Zoom In/Out button until the action you want
appears. Action determines how the system will respond when motion is detected. Choices
are:
• No Action* – no action occurs
• Preset (1-96) – calls a Preset
• Pattern (1-16) – runs a Pattern
• Output (1-4) – activates an output.
* When No Action is programmed on the Motion Detection Setup screen, the dome’s
return to a Home position is delayed as long as motion occurs within the time specified on
the return-to-home screen.
10. Press Focus Far. The Active Zone Position Programming screen appears (
Figure 54).
Figure 54. Active zone position programming screen (35X camera dome)
11. Using the joystick, move the rectangular zone indicator to a desired location, and then
press Focus Far to save and exit.
Note: The rectangular zone indicator appears on-screen when the joystick is
moved.
12. Repeat steps 6 through 11 to create additional detection zones (1-8).
When the Motion Detection Setup screen appears, highlight Exit and press Focus
In/Out to save the setting. Motion detection works in conjunction with existing Presets.
MOTION DETECTION SETUP
ZONE 1
ESC/FOCUS=save+exit
Rectangular
zone
indicator