Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. C
OPERATOR’S GUIDE
60 of 138
Note: If you change the parameters in the Camera Functions menu and/or
change the motion detection setup for an existing Preset, you will need to
reprogram the Preset to save the changes.
Follow the steps below to change camera functions and/or motion detection within Presets:
1. Access the Dome Configuration Menu (
Figure 50) by pressing Iris Open, Focus Far,
and Zoom Out on your controller.
Figure 50. Dome Configuration Menu screen
2. Highlight Alarms / Areas / Home / Presets / PZ and press Focus Far to select. The
Alarms / Areas / Home / Presets / PZ screen appears.
Figure 51. Alarms/Areas/Home/Presets/PZ screen
3. Highlight Presets and press Focus Far to select. The Select Preset To Program
screen appears (
Figure 52).
ALARMS/AREAS/HOME/PRESETS/PZ
SET ALARM ACTIONS
SET ALARM STATES
SET HOME POSITION
SET NORTH POSITION
AREA BOUNDARIES
PRIVACY ZONES
PRESETS
SCAN LIMITS
EXIT
DOME CONFIGURATION MENU
PAN/TILT/ZOOM/SYNC OPTS
CAMERA FUNCTIONS
ALARMS/AREAS/HOME/PRESETS/PZ
ON-SCREEN TEXT DISPLAY
LANGUAGE / PASSWORD
DOME INFORMATION
RESET TO FACTORY SETTINGS
QUIT WITHOUT SAVING
EXIT AND SAVE CHANGES