Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. C
OPERATOR’S GUIDE
59 of 138
Figure 49. Pattern Select screen
2. Highlight a desired Pattern number (1-16). Press Focus Far to continue.
3. Pan/tilt/zoom the dome as desired for the Pattern.
4. Execute the keyboard’s Pattern save command to save the Pattern.
Running 16 Patterns
When a dome is configured for 16 Patterns, running a Pattern requires displaying the Pattern
Select screen (
Figure 49). Follow the steps below to run a Pattern.
1. Enter the appropriate keyboard command to run Patterns 1, 2, or 3. The Pattern Select
screen appears.
2. Highlight the desired Pattern number (1-16) to run.
3. Press Focus Far to select. The Pattern Select screen disappears and the Pattern runs.
Note: If the controller being used supports the use of 16 Patterns, the 16 Pattern
Feature will execute patterns 1-16 automatically.
Changing Camera Functions and Motion Detection Setup within
Presets
When Presets are created, they adopt the dome parameters defined in the Camera Functions
screen and/or the Motion Detection screen. You can now customize camera functions for each
Preset by accessing the Camera Functions screen, or you can set up motion detection by
accessing the Motion Detection Setup screen from the Presets screen.
PATTERN SELECT
1 5 9 13
2 6 10 14
3 7 11 15
4 8 12 16
FOCUS FAR TO CONTINUE