Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. C
OPERATOR’S GUIDE
55 of 138
10. Repeat steps 7 through 9 above until the first 4 presets have been programmed. If more
Presets are desired, highlight the Step field and use Zoom In/Out to display sequence
steps 5-8.
11. When finished, highlight Exit and press Focus Far to select.
12. At the Dome Configuration Menu screen, highlight Exit and Save Changes and
press Focus Far to save.
Running Sequences 1-16
Two options are available for running Sequences:
• Option 1 – If your keyboard supports the DirectSet command, you can use it to run a
Sequence immediately (see
Accessing the DirectSet Menu on page 12). Consult your
keyboard manual for information on DirectSet functions.
• Option 2 - Use the Set Home Position method to schedule one Sequence to run when the
dome returns to its home position (after a defined period of inactivity).
Follow the steps below to run Sequences from the Set Home Position screen:
1. Access the Dome Configuration Menu (
Figure 44) by pressing Iris Open, Focus Far,
and Zoom Out on your controller.
Figure 44. Dome Configuration Menu screen
2. Highlight Alarms / Areas / Home / Presets / PZ and press Focus Far to select. The
Alarms/Areas/Home/Presets/PZ screen (
Figure 45) appears.
DOME CONFIGURATION MENU
PAN/TILT/ZOOM/SYNC OPTS
CAMERA FUNCTIONS
ALARMS/AREAS/HOME/PRESETS/PZ
ON-SCREEN TEXT DISPLAY
LANGUAGE / PASSWORD
DOME INFORMATION
RESET TO FACTORY SETTINGS
QUIT WITHOUT SAVING
EXIT AND SAVE CHANGES