Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. C
OPERATOR’S GUIDE
52 of 138
4. The following prompt appears:
YOU ARE ABOUT TO DELETE
ALL PRIVACY ZONES
CANCEL
CONTINUE
5. To delete all Privacy Zones, select Continue.
If you do not want to delete all Privacy Zones, select Cancel. The Program Privacy
Zones screen displays.
6. Select Exit to return to Alarms/Areas/Home/Presets/PZ screen.
7. When the Alarms/Areas/Home/Presets/PZ screen appears, select Exit. The Dome
Configuration Menu appears.
Hiding Privacy Zones
If you want to temporarily disable the appearance of Privacy Zones, you may “hide” them.
This allows you to keep the Privacy Zones that have been programmed while disabling their
appearance on-screen.
To hide all Privacy Zones:
1. Select Alarms/Areas/Home/Presets/PZ from the Dome Configuration Menu.
2. Select Privacy Zones.
The Program Privacy Zones screen displays.
3. Select Hide All Zones. Change the setting.
• Select Yes to hide all Privacy Zones.
• Select No to make all Privacy Zones active.
The default setting is No.
4. Select Exit to return to Alarms/Areas/Home/Presets/PZ screen.
5. When the Alarms/Areas/Home/Presets/PZ screen appears, select Exit. The Dome
Configuration Menu appears.
Programming Sequences
A Sequence is a sequential display of multiple camera Presets. Sequences provide a methodical
and effective way to monitor multiple areas of interest by switching to different Presets
automatically. Sequences are programmed from the Select Preset to Program screen.
Sequences are created by identifying Preset views to include in the Sequence and specifying a
dwell time that controls how long each Preset remains on-screen before switching to another
Preset. Up to 16 Sequences can be created, each with 16 steps (Presets).
Steps to Programming Sequences
Follow the steps below to program Sequences.
1. Access the Dome Configuration Menu (
Figure 40) by pressing Iris Open, Focus Far,
and Zoom Out on your controller.