Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. C
OPERATOR’S GUIDE
49 of 138
Figure 37. Privacy Zone Programming screen
The circled arrows represent the target area on the screen for creating the Privacy Zone.
Normally, this target area remains in the center of the screen. Using the Pan/Tilt control
moves the target area by panning or tilting the dome. If the dome reaches its maximum tilt
position, the Privacy Zone may still be established in the upper part of the display. When this
occurs, the arrows move relative to the movement of the Pan/Tilt control until the top of the
display area is reached.
The boundary points on the Privacy Zone are selected by pressing Zoom. Once a boundary
point is selected, the arrows “blink” until the target area is moved to a valid area. Once the
target moves to a valid area, the arrows stop blinking. If you move the target more than 90-
degrees from a selected point, the arrows begin to blink again, indicating that the boundary is
too large.
If you attempt to establish a boundary point while the arrows are blinking you will receive an
error message: Zone is Too Small or Zone is Too Large. If this happens, you must start
programming from the beginning. Pressing Focus Far returns you to the Privacy Zone
programming screen.
If you attempt to program more than eight Privacy Zones, the following message appears:
Maximum Allowed Number of Zones Defined
Pressing Focus Far returns to the Program Privacy Zones screen. To program a new zone,
you must delete at least one of the eight existing Privacy Zones. See
Removing or Hiding
Privacy Zones on page
50.
IMPORTANT
Areas of the Privacy Zone may be exposed during rapid pan / tilt movements of the
dome. To compensate for this limitation, you may want to program the Privacy
Zone to be 20 to 25% larger than the area you want to mask.
NEW PRIVACY ZONE
Navigate corner 1
ZOOM to mark corner
FOCUS to abandon zone