Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. C
OPERATOR’S GUIDE
48 of 138
Figure 35. Privacy Zones screen
From this screen, you can program up to eight Privacy Zones, delete all or specific Privacy
Zones, or temporarily hide all Privacy Zones.
How Privacy Zones are Programmed
Privacy Zones are established by selecting three points on the display image to mask. The
fourth point on the Privacy Zone is automatically generated by mirroring the longest axis
between the three selected points.
Figure 36 illustrates how Privacy Zones are programmed.
Figure 36. Privacy Zone programming example
+
+
+
+
The dome’s firmware prevents you from establishing a zone that is too small or too large
(greater than 90-degrees pan or tilt from the starting point).
Figure 37 illustrates the Privacy Zone programming screen:
PRIVACY ZONES
ADD PRIVACY ZONE
DELETE SPECIFIC ZONES
DELETE ALL ZONES
HIDE ALL ZONES NO
EXIT
Point 1
Point 2
Point 3
Point 4 mirrors
the longest axis.