Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. C
OPERATOR’S GUIDE
45 of 138
Figure 33. An example of areas found in a break room
V
ending Machines
Lockers
Entrance
Emergency
Exit
The ending point of one area is the starting point for the next area. The ending point of the last
area cannot go past the starting point of the first area. In this example, the area that includes
the vending machines cannot extend past the starting point of the area that includes the
emergency exit. If your controller supports areas, these are separate from the areas you can
program with the dome. You should not use both the controller and the configuration utility to
define areas.
The zoom level also affects how large areas appear. When you zoom in to an area, the area
may appear to be small. When you pan the dome, area boundaries may appear to be close.
However, if you zoom out, the area appears to be larger. When you pan the dome, the area
boundaries appear further apart. With this in mind, it will be easier to establish area boundaries
if the zoom level is small than if the zoom level is large.
Note: When areas are programmed, each area is assigned a default name.
Instructions for assigning new names appear in
Chapter 5: Configuring Text
Displayed On-Screen on page
71.
Start of Area 1/
End of Area 8
A
rea
1
A
rea
2
Area
3
A
rea
4
A
rea
5
A
rea
6
A
rea
7
A
rea
8
Dome
Areas appear smalle
r
when zoomed in.
Areas appear lar
g
er when
zoomed out.