Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. C

OPERATOR’S GUIDE

2 of 138

EQUIPMENT MODIFICATION CAUTION

Equipment changes or modifications not expressly approved by Sensormatic Electronics Corporation, the

party responsible for FCC compliance, could void the user's authority to operate the equipment and could

create a hazardous condition.

FCC COMPLIANCE

This equipment has been tested and complies with the limits for a Class A digital device, according to

Part 15 of the FCC Rules. These limits provide reasonable protection against harmful interference when

the equipment operates in a commercial environment. This equipment generates, uses, and can radiate

radio frequency energy, and, if not installed and used according to these instructions, may cause harmful

interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference. If this equipment

is used in a residential area, users must correct the interference at their own expense.

LIMITED RIGHTS NOTICE

For units of the Department of Defense, all documentation and manuals were developed at private

expense and no part of it was developed using Government Funds. The restrictions governing the use and

disclosure of technical data marked with this legend are set forth in the definition of "limited rights" in

paragraph (a) (15) of the clause of DFARS 252.227.7013. Unpublished - rights reserved under the

SOFTWARE LICENSE AGREEMENT

A Software License Agreement appears in

Appendix I: End User License Agreement of this manual.

Please read it carefully. Using the SpeedDome Ultra 8 Camera Dome Configuration Utility software

indicates that you accept the terms and conditions of this agreement.

NOTICE

The information in this manual was current when published. The manufacturer reserves the right to revise

and improve its products. All specifications are therefore subject to change without notice.

Under copyright laws, the contents of this manual may not be copied, photocopied, reproduced, translated

or reduced to any electronic medium or machine-readable form, in whole or in part, without prior written

consent of Sensormatic Electronics.

American Dynamics and SpeedDome are trademarks or registered trademarks of Sensormatic Electronics

Corporation. Product names mentioned herein may be trademarks or registered trademarks of other

companies.

Thank you for using American Dynamics products. We support our products through an extensive and

worldwide network of dealers. The dealer, through whom you originally purchased this product, is your

point of contact if you have a need for service or support. Our dealers are fully empowered to provide the

very best in customer service and support. Dealers should contact American Dynamics at (800) 507-6268

or (561) 912-6259, or on the web at www.americandynamics.net.