Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. C

OPERATOR’S GUIDE

11 of 138

Restoring Factory Settings

Some screens provide a choice to restore factory settings. This choice applies only to those

settings currently displayed on the screen. To reset all configuration settings, choose Reset to

Factory Settings from the Dome Configuration Menu. The following prompt appears:

Reset to Factory Settings

Press Zoom to display the options.

• If you want to restore the factory settings, select Yes.

• If you do not want to restore the factory settings, select No.

Press Focus to accept the displayed option.

IMPORTANT

Selecting Reset to Factory Settings from the Dome Configuration Menu does

not change the following settings: Camera Name, Alarm Names, Area Names, Preset

Names, Pattern Names, Area Boundaries, Privacy Zones, and Presets. To reset

names to the default settings, see

Chapter 5: Configuring Text Displayed On-

Screen.

Exiting the Configuration Utility

Under SensorNet, RS-422, and Manchester protocols, you can save your changes and exit the

utility from any screen by pressing and holding Iris Close, then pressing Focus. From the

Dome Configuration Menu, you have two choices for exiting the utility: Exit and Save

Changes or Quit Without Saving. Use the Pan/Tilt control to move the highlight bar up

and down on the screen.

• If you want to keep the changes you made, move the highlight bar to Exit and Save

Changes, and select. The utility closes.

• If you want to exit without making changes, move the highlight bar to Quit Without

Saving, and select. The following prompt appears on the screen:

Data Not Saved, Quit Anyway?

Press Zoom to display the options.

• To cancel the changes, select Yes.

• To keep the changes, select No. If you choose No, the Dome Configuration Menu is

displayed.

Press Focus to accept the displayed option.