Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. C
OPERATOR’S GUIDE
122 of 138
Note: If both the Left and Right scan limits are set to the same position, the
dome continuously pans to the right when Auto Pan is activated.
Setting the Auto Pan Speed
1. Press and hold A/P key.
2. Move joystick to Pan Right until the desired speed is observed on the monitor.
3. Release the A/P key.
4. Release the joystick.
Activating Auto Pan
Auto Pan allows the dome to continuously pan between the left and right scan limit settings.
To start Auto Pan, press the A/P key. If no scan limit settings are programmed, the dome pans
to the right continuously.
Note: Auto Pan will be cancelled if the operator issues a Pan, Flip, Preset, or
Pattern command.
Tested Vicon Equipment
The following Vicon equipment has been tested with the SpeedDome Ultra 8 camera dome:
• Vicon 1300 CPU Systems
• Vicon 1400 CPU Systems
• Vicon 1500 CPU Systems
• Vicon VPS 324