Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. C
OPERATOR’S GUIDE
120 of 138
If you want to … Use …
Repeat Pattern 1-3
Run/Pgm switch to RUN
Enter 83-85 Enter
Set Pattern to Peel Enter 89 Enter
Vphase Dome
Note: The A/I LED blinks indicating that you are in the
vphase mode. Enter key sequence again to turn vphase
adjustment off. The A/I LED stops blinking and indicates
Auto Iris State.
Run/Pgm switch to PGM
Enter 93 Enter
• Pan Right to increment
• Pan Left to decrement
Start Dome Configuration Menu
See
Operating the Dome Configuration Menu on
page
120.
Enter 94 Enter
Turn IR Mode On
Run/Pgm switch to PGM
Enter 95 Enter
Turn IR Mode Off
Run/Pgm switch to PGM
Enter 96 Enter
Reset Dome
Run/Pgm switch to PGM
Enter 97 Enter
Auto Pan Left Limit
See
Setting Left and Right Auto Pan Scan Limits on
page
121.
Run/Pgm switch to PGM
Enter 98 Enter
Auto Pan Right Limit
See
Setting Left and Right Auto Pan Scan Limits on
page
121.
Run/Pgm switch to PGM
Enter 99 Enter
Auto Pan ON/OFF
(LED indicates Auto Pan state: ON = Auto Pan is running.)
Run/Pgm switch to RUN
A/P toggles state
Operating the Dome Configuration Menu
The following table lists the commands to operate the configuration utility when the dome is
installed in a Vicon environment.
If you want to … Use …
Start the configuration utility. Run/Pgm switch to PGM
Enter 94 Enter
Move the highlight bar on the active menu.
Tilt Up/Down
Select the highlighted item on the active menu. A/P or AUX5
Increase the value of the selected setting.
For example, Red or Blue white balance values.
Pan Right (or Zoom In)
Decrease the value of the selected field.
For example, Red or Blue white balance values.
Pan Left (or Zoom Out)
Display the next choice for the setting. For example, Pan Right (or Zoom In)