Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. C
OPERATOR’S GUIDE
119 of 138
Appendix F: Vicon Command Summary
This appendix summarizes the SpeedDome Ultra 8 camera dome features that are supported by
the Vicon protocol. In addition, it provides the controller commands used with the
Configuration Utility. It also provides information about tested Vicon equipment and
supported Vicon features.
Supported SpeedDome Ultra 8 Camera Dome Features
With the following exceptions, the SpeedDome Ultra 8 camera dome supports the feature set
described in this operator’s guide when controlled with the Vicon protocol.
Unsupported SpeedDome Ultra 8Camera Dome Features
• Vicon controllers that do not support as many presets, patterns, or outputs as the
SpeedDome Ultra 8 camera dome are limited to the maximum quantities they are designed
to support.
Vicon Command Summary
The following table lists the Vicon controller key sequence to control the indicated
SpeedDome Ultra 8 camera dome functions.
If you want to … Use …
Set Auto Iris ON/OFF
(LED indicates Auto Iris state: ON = AUTO)
A/I Toggles state
Set Auto Focus ON/OFF
(LED indicates Auto Focus state: ON = AUTO)
Press and Hold L-Spd
A/P Toggles state
Goto Presets
Run/Pgm switch to RUN
Enter 1-79 Enter
Program Presets
Run/Pgm switch to PGM
Enter 1-79 Enter
Run PEEL Pattern and Repeat
AUX5
Rotate dome 180° (“Flip”) AUX6
Start Pattern 1-3 Definition Run/Pgm switch to PGM
Enter 80-82 Enter
End Pattern Definition Run/Pgm switch to PGM
Enter 86 Enter
Review Pattern
Run/Pgm switch to PGM
Enter 87 Enter
Accept Pattern
Run/Pgm switch to PGM
Enter 88 Enter
Run Pattern 1-3
Run/Pgm switch to RUN
Enter 80-82 Enter