Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. C
OPERATOR’S GUIDE
113 of 138
Appendix E: AD Up-the-Coax (UTC) Command Summary
This appendix summarizes the AD-UTC controller commands used with the Configuration
Utility. It also provides a list of additional AD-UTC commands that can be used with the dome
and compatible controllers.
Command Summary
The following table lists the commands to operate the configuration utility when the dome is
installed in an AD-UTC environment. The keyboard must be in programming mode to perform
these functions.
If you want to … Use …
Start the configuration utility.
F
, +
(Function, and then Shift+Menu)
Move the highlight bar on the active menu. Use the Joystick
(Pan/Tilt)
Select the highlighted item on the active menu.
or
(Focus Far or Focus Near)
Increase the value of the selected setting.
For example, Red or Blue white balance values.
(Zoom In) or
Twist joystick clockwise
Decrease the value of the selected field. For example,
Red or Blue white balance values.
(Zoom Out) or
Twist joystick counter-clockwise
Display the next choice for the setting. For example,
Maximum Zoom setting.
(Zoom In)
Display the previous choice for the setting. For
example, Maximum Zoom setting.
(Zoom Out)
Save changes and exit the utility from any screen.
F
, +
(Function, and then Shift+Clear)
Setting Names / Working with Passwords
When setting names or entering password information, the screen displays the available
characters in the selected languages. In these situations, the following commands are used:
If you want to … Use …
Move the highlight left or right in the character field.
Joystick Left/Right
Move the highlight up or down in the character field.
Joystick Tilt Up/Down