Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. C
OPERATOR’S GUIDE
110 of 138
Setting Names / Working with Passwords
When setting names or entering password information, the screen displays the available
characters in the selected languages. In these situations, the following commands are used:
If you want to … Use …
Move the highlight left or right in the character field.
ALT enabled, Left/Right
Move the highlight up or down in the character field.
ALT enabled, Up/Down
Select the highlighted character in the character field.
SET
Move the cursor to the right of the current character in the
name or password.
ALT disabled, Right
Or
ALT enabled, Zoom Tele
Move the cursor to the left of the current character in the
name.
ALT disabled, Left
Or
ALT enabled, Zoom Wide
Performance Notes
When selecting a dome, a 3- to 5-second delay is necessary for the Panasonic multiplexer to
properly identify the dome type. If the dome is moved before the interrogation is complete, the
controller recognizes the dome as a “single speed” dome. Once the dome stops moving and the
interrogation completes, the normal 8 speed settings are available.
Address Setting
The dome must have the correct address setting to operate with Panasonic UTC protocol. Set
the dome address switches to 890.
Programming Presets
You must use the Dome Configuration Menu to program Presets. Up to 64 Presets may be
programmed.
Note: This procedure has been verified using the following equipment:
• WJ-SX550 Multiplexer
• WV-CU550A Controller
1. Select the monitor and camera number assigned to the Speed Dome Ultra 8 camera dome.
2. Use the arrow keys on the controller to scroll to the Camera Setup Menu (D4).
3. Press the F1 (On) key to display the Dome Configuration Menu.
4. Use the joystick to move the highlight to Alarms/Areas/Home/Presets/PZ. Press Set
to select.