Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. C
OPERATOR’S GUIDE
106 of 138
Setting Names / Working with Passwords
When setting names or entering password information, the screen displays the available
characters in the selected languages. In these situations, the following commands are used:
If you want to … Use …
Move the highlight left or right in the character field.
Pan
Move the highlight up or down in the character field.
Tilt
Select the highlighted character in the character field.
Iris Open (or Focus)
Move the cursor to the right of the current character in the
name or password.
Pan Right (or Zoom In)
Move the cursor to the left of the current character in the
name.
Pan Left (or Zoom Out)
Additional Controller Commands
Use the following controller commands to perform these SpeedDome Ultra functions:
If you want to... Use...
Flip the dome 180°
Call Preset 33
Return to 0° pan
Call Preset 34
Turn IR Mode On
Set Preset 88
Turn IR Mode Off
Set Preset 89
Reset Dome
Set Preset 94
Performance Notes
The following SpeedDome Ultra 8 camera dome features are not supported with the Pelco
protocols:
• PAL video format. This will be supported after further testing.
• Long line length applications that require video amplifiers or fiber optics.
Address Settings
The dome must have the correct address setting to operate with Pelco Coaxitron and “P”
protocols. For Coaxitron protocol, the address must be set to 893. For “P” protocol, the
address setting is based upon the baud rate setting:
• For 2400 baud, the x100 switch must be set to 6; the x10 and x1 switches may be set to
any number.
• For 4800 baud, the x100 switch must be set to 0; the x10 and x1 switches may be set to
any number.
• For 9600 baud, the x100 switch must be set to 7, the x10 and x1 switches may set to any
number.