Technical data

SPEEDDOME ULTRA 8 CONFIGURATION UTILITY 8200-0600-01, REV. C
OPERATOR’S GUIDE
105 of 138
Appendix C: Pelco Coaxitron and “P” Protocols Command
Summary
This appendix summarizes the SpeedDome Ultra 8 camera dome features that are supported by
the Pelco Coaxitron and “P” protocols. In addition, it provides the controller commands used
with the Configuration Utility. It also supplies information about tested Pelco equipment and
supported Pelco features.
Supported SpeedDome Ultra 8 Camera Dome Features
With the following exceptions, the SpeedDome Ultra 8 camera dome supports the feature set
described in this operator’s guide when controlled with Pelco Coaxitron and “P” protocols.
Unsupported SpeedDome Ultra 8 Camera Dome Features
• Pelco controllers that do not support as many presets, patterns, or outputs as the
SpeedDome Ultra 8 camera dome are limited to the maximum quantities they are designed
to support.
• Saving and exiting from configuration menus using Iris Close and Focus keys
• Apple Peel pattern (default SpeedDome pattern)
• V-Phase adjustment
Pelco Command Summary
The following table lists the commands to operate the configuration utility when the dome is
installed in a Pelco environment.
If you want to … Use …
Start the configuration utility.
Set Preset 95
Move the highlight bar on the active menu.
Tilt Up/Down
Select the highlighted item on the active menu.
Iris Open (or Focus)
Increase the value of the selected setting. For example, Red or
Blue white balance values.
Pan Right (or Zoom In)
Decrease the value of the selected field. For example, Red or
Blue white balance values.
Pan Left (or Zoom Out)
Display the next choice for the setting. For example,
Maximum Zoom setting.
Pan Right (or Zoom In)
Display the previous choice for the setting. For example,
Maximum Zoom setting.
Pan Left (or Zoom Out)