Specifications

D. Connect the dome to the housing
1. Align the protrusion at the top of the dome with
the “white line” on the environmental PC board
(or with the protrusion on the base).
2. Mate the dome to the base and turn it
clockwise until you hear a click.
WARNING! Heater fans must
work! If either or both fans are off,
the dome could overheat.
Note: When power is connected to the camera
dome, it performs the following homing routine.
a. After a few seconds, the heater fans turn
on and the camera lens tilts up into the
camera dome.
b. The lens tilts downs until it looks at the
floor.
c. Eyeball pans slowly.
d. Lens tilts up 90° (home position). The
controller can then be used to call up the
camera and control it.
L
O
C
K
Attaching the Bubble Assembly
to the Housing
1. Remove the bubble assembly from its box and
ensure it is clean and free of debris.
2. Remove the “CAUTION: Remove slot covers”
tag. Ensure slot covers are removed from the
dome.
3. On the bubble assembly is a lanyard. Attach
the lanyard to the threaded stud on the
housing using the thumbnut.
4. Molded into the bubble assembly is a key.
Align the key with the detent on the edge of the
housing.
5. Secure the assembly to the housing using the
four tamperproof screws. Use the drive (taped
inside the bubble) to tighten the screws.
CAUTION: Maintain the gasket seal between
the housing and the bubble assembly by not
letting the lanyard get caught between these
two pieces as you secure the bubble to the
housing.
Note: If a problem arises, see Appendix B:
Troubleshooting.
!
Sun Shield
Stud
Lanyard
Detent
Key
(molded
into bubble
assy.)
A
lign Lock
White li
on PC
Board
ne
RHODUL-03VR/-04VR SPEEDDOME ULTRA VANDAL-RESISTANT OUTDOOR HOUSING 8200-0184-11, REV. A
INSTALLATION AND SERVICE GUIDE
8 of 14