Specifications

Attaching the Housing to the
Mounting Structure
WARNING! Turn power off at the source
before beginning this procedure.
If a “Street L” pipe or elbow is attached to the
mounting structure, it does not mate with the
housing. Instead, replace it with the ROENDC
adapter pipe shown below.
WARNING! Additional instructions for
outdoor mounting are supplied with the
mounting structure. To maintain the
NEMA 4 IP66 rating, follow these
instructions.
Parts Required
Install Kit 0351-2183-05
Connector, 3-Position, Power (green) 1 2109-0651-03
Connector, 4-Position, Alarm (blue) 1 2109-0804-04
Connector, 5-Position, Alarm (gray) 1 2109-0650-05
Connector, 6-Position, Data (black) 1 2109-0648-06
1. Connect video, power, data, and alarm cables
from the J-box to the cable connectors exiting
the housing.
Note: See Appendix A: Cable Requirements
for cable criteria.
Video
Video connects to the BNC connector exiting
the housing.
Power
Power connects to the green 3-pin connector.
Pin Color Description
1 N/A 24Vac
2 N/A Common
3 N/A 24Vac
Data
Data connects to the black 6-pin connector
(Manchester, RS422, or SensorNet).
Manchester
Pin Color* Designation
1-4 — Not used.
5 Black Manchester (+)
6 White Manchester (–)
RS422
Pin Color* Designation
1 Orange RS422 Data In High (+)
2 Green RS422 Data In Low (–)
3 Yellow RS422 Data Out High (+)
4 Brown RS422 Data Out Low (–)
5-6 — Not used.
SensorNet
Pin Color* Designation
1-4 — Not used.
5 Brown SensorNet (unshielded)
6 Yellow SensorNet (unshielded)
*Color based on composite cable.
!
!
A
dapter Pipe
5-Pin
Connector
6-Pin
Connector
3-Pin
Connector
4-Pin
Connector
Video
BNC
RHODUL-03VR/-04VR SPEEDDOME ULTRA VANDAL-RESISTANT OUTDOOR HOUSING 8200-0184-11, REV. A
INSTALLATION AND SERVICE GUIDE
5 of 14