Operator`s manual

RCTT16BE VM16 PLUS ENHANCED TOUCH TRACKER 8000-2672-01, REV. D1
INSTALLATION GUIDE
3 of 15
Installation Diagrams
The following pages illustrate the installation of the
VM16+ Enhanced Touch Tracker in the following
configurations:
Enhanced Touch Tracker with Multiplexer
(DB25 connection)................................................4
Enhanced Touch Tracker with Multiplexer
(RJ11 connection) ................................................5
Enhanced Touch Tracker with Quad Splitter
(RJ45 connection) ................................................6
Enhanced Touch Tracker with RVQX7X Quad
Splitter ...................................................................7
Enhanced T
OUCH TRACKER with Intellex 1.x ...... 8
Enhanced Touch Tracker with Intellex 2.0.........9
Enhanced Touch Tracker with Intellex 2.1.......10
Enhanced Touch Tracker and Duplex Remote
Panel (RVDRP) ...................................................11
Enhanced T
OUCH TRACKER with Domes Only (No
External Unit) ......................................................12
Refer to the appropriate diagram when connecting
the Enhanced Touch Tracker.
Installation Notes
• Depending on configuration, two Enhanced
TOUCH TRACKERS may be installed. Terminate
E1 on the EIM that is on the end point of the
SensorNet Network.
• The maximum combined SensorNet cable
length is 1000 m (one km or 3000').
• J-Box and dome wiring information is included
for information purposes only. Refer to the
J-Box or dome installation instructions for
complete wiring information.