Operator`s manual

MEGAPOWER 48 / ADTTE 8200-0170-05, REV. A
OPERATION AND PROGRAMMING REFERENCE GUIDE 7 of 43
General User Tasks
The following tasks can be performed regardless
of the keyboard lock setting.
• Log On
• Log Off
Logging On
If UC appears in the Camera display of your
keyboard, User Codes and Passcodes have
been implemented at your facility. You must log
on before attempting to use the system.
Note: MP48 provides a default passcode for user
1. The default passcode is 914365. To prevent
unauthorized use of the system, this passcode
should be changed. See Changing User
Settings on page 30.
1. UC (User Code) appears on the LCD.
2. Enter the User Code (1-64). Press User.
3. PSC (Passcode) appears on the LCD.
4. Enter the passcode (up to 6 digits). Press
User.
Once logged on, you can begin performing other
tasks.
Logging Off
When the MP48 system is not in use, you should
log off the system. This will ensure that
unauthorized users cannot control your system.
1. Enter 99.
2. Press F1 (located to the left of the LCD
display.
STS MON CAM 99
005 168 -L
F
1
F
2
3. UC (User Code) appears on the LCD to
indicate successful log off.
Working in Keyboard Lock
Mode
STS MON CAM 1234
005 168 -L
When the keyboard is in the Lock mode, the
following MP48 tasks can be performed.
Table 2: Operate Mode Tasks
Task Page
Selecting Monitors
8
Selecting Cameras and Domes
8
Locking Cameras and Domes
8
Controlling Cameras and Domes
9
Calling Presets
10
Running Patterns
10
Controlling Tours
11
Controlling Auxiliary Devices
12
Acknowledging Alarms
12
Running Salvos
13
Note: These tasks may also be performed using
programming mode. However, users without
programming privileges are limited to performing
only these tasks.
Enter 99
then press F1
to log off.