Operator`s manual

MEGAPOWER 48 / ADTTE 8200-0170-05, REV. A
OPERATION AND PROGRAMMING REFERENCE GUIDE 6 of 43
M. (Camera): Calls the camera number
entered using the numeric keypad.
N.
(Monitor): Calls the monitor number
entered using the numeric keypad.
O. CLEAR: Removes numbers entered on the
numeric keypad.
P. NEXT (→): Multi-function key used to display
the next camera in sequence during a monitor
tour or an alarm tour that is on hold. Also
serves as the Cursor Right function during
menu programming.
Q. LAST (←): Multi-function key used to display
the previous camera in sequence during a
monitor tour or an alarm tour that is on hold.
Also serves as the Cursor Left function
during menu programming.
R. SALVO: Used to display a pre-defined group
(salvo) of camera inputs on a group of
contiguous of monitors, beginning with the
currently selected monitor.
S. Site: Used to control satellite systems. This
feature is not supported on the MP48 system.
T. Run (↑): Multi-function key used to start a
monitor tour, universal (system) tour, or alarm
tour. Also serves as the Cursor Up function
during menu programming.
Hold (↓): Multi-function key used to pause a
monitor tour, universal (system) tour, or alarm
tour. Also serves as the Cursor Down
function during menu programming.
U. User: Used to authorized users to log on to
the system.
V. Mon Arm On: Used to enable system alarms
to appear on monitors. This feature is under
keyboard lock protection.
Mon Arm Off: Used to disable system alarms
from appearing on monitors. This feature is
under keyboard lock protection.
W. Prog: Used to program monitor tours and
other system programming features. This
button is under keyboard lock protection.
X. F2: Function key whose use varies
depending upon the feature being accessed.
Y. F1: Function key whose use varies
depending upon the feature being accessed.
The F1 button is also used to set the baud
rate and display the firmware version
information for the ADTTE.
Identifying the ADTTE
Operating Mode
The current operating mode of the ADTTE
keyboard can be determined by looking at the
lower-right corner of the LCD.
Table 1: ADTTE modes
Display Reading Mode
STS MON CAM 1234
005 168 -L
L: Keyboard Lock mode.
Only basic functions
available.
STS MON CAM 1234
005 168 +P
STS MON CAM 1234
005 168 -P
+P: Programming mode.
When + is displayed,
Presets can be programmed.
-P: Program Recall mode.
When – is displayed, Presets
cannot be programmed, only
recalled.
STS MON CAM 1234
005 168 -M
M: Menu mode.
Multi-function keys provide
secondary functions.
See the following sections:
General User Tasks ...................................... 7
Working in Keyboard Lock Mode ................ 7
Working in Program Mode ......................... 14
Working in Menu Mode............................... 22