Operator`s manual
Table Of Contents
- Using MegaPower® 48 Matrix Switcher with ADTTE Keyboard Cont
- About this Guide
- About the MegaPower 48 Matrix Switcher/Controller System
- About the ADTTE Keyboard Controller
- Identifying the ADTTE Operating Mode
- General User Tasks
- Working in Keyboard Lock Mode
- Working in Program Mode
- Changing ADTTE Keyboard Settings
- Working in Menu Mode
- Changing System Settings
- Changing Monitor Settings
- Changing Camera Settings
- Configuring User or Keyboard Settings
- Configuring Switching Settings
- System Partitioning
- Configuring Alarms
- Declarations
MEGAPOWER 48 / ADTTE 8200-0170-05, REV. A
OPERATION AND PROGRAMMING REFERENCE GUIDE 26 of 43
Viewing Monitor Status
Use Monitor Status to determine the current
camera, tour, status, and sync mode for each
monitor.
MONITOR STATUS
MONCAM STS T OURSYNC
01 0024 R 02 Y
02 0001 H 64 N
03 0048 A N
04 0012 S Y
05 0007 S - - N
06 0040 S - - Y
07 0005 S - - N
08 0036 S - - N
--
--
No changes can be made from this screen. Two
pages of information are available. Use the Page
Up (Iris Close) and Page Down (Iris Open) to view
the pages.
The following information is displayed:
Setting Description
Mon
Monitor Number. Page 1 displays
monitors 1-8; page 2 displays
monitors 9-16.
Cam
Camera number. The number
displayed may be the real number or
pseudo number.
Sts
Status information. The following
codes appear:
• R (Run)
• H (Hold)
• A (Alarm)
• S (Salvo)
Tour
Tour number currently running or on
hold.
Sync
Camera sync display code.
• Y indicates that a sync (video)
signal is present.
• N indicates loss of sync.
Configuring Paging Profiles
Use Paging Profile to create special profiles for
sending messages to paging devices.
EDIT PAGING PROFI LE - 01
1 2 3 4 5 6 7 8 9 * 0 #
PHONE NUMBER
-------------------------------
PERSONAL ID NUMBER
----------------
The following settings may be configured:
Setting Options
Phone
Number
Up to 32 characters (1-9, *, #) for
automatic dialing of the paging
service.
Personal
ID
number
Up to 16 characters used to provide
an identifier to the paging service.
Prerequisites for Implementing Paging
The following prerequisites are necessary when
implementing paging with the MP48.
• An analog telephone line must be used for dial-
up. MP48 paging will not work with a digital
telephone line.
• An external (AT Command Set) modem
• Subscription to a telecommunications service
provider. The service provider must support the
Telocator Alphanumeric Protocol (TAP). The
external modem wired to the MP48 must
communicate directly with the service provider’s
computer.
• Personal Identification Numbers (PINs)
assigned by the service provider to the remote
paging devices that will receive transmissions.
Characte
r
selection