Operator`s manual

MEGAPOWER 48 / ADTTE 8200-0170-05, REV. A
OPERATION AND PROGRAMMING REFERENCE GUIDE 21 of 43
Adjusting the Key Click Volume
1. Press number 2, and then press Config.
2. Use the + and – buttons (located near the right
side of the LCD) to adjust the volume.
• Press + to make the key click volume louder.
• Press – to make the key click volume softer.
3. When the volume is at the preferred level, press
Clear to refresh the LCD.
Changing the Language Setting
The LCD information on your keyboard can be
displayed in a number of languages, including:
• English • Spanish
• German • Portuguese
• French • Italian
To change the language appearing on the LCD:
1. Enter 35, and then press Config.
2. Press Next to scroll through the language
choices.
3. Press Ack when the correct language choice
appears on the LCD.
After the keyboard resets, messages on the LCD
appear in the selected language.
Displaying the Touch Tracker
Baud Setting
Enter 3 and press F1 to display the current baud
setting for the ADTTE Touch Tracker.
Changing the Baud Rate
The ADTTE keyboard supports four baud rates:
1200, 2400, 4800, and 9600 baud. The default
setting for the baud rate is 1200.
IMPORTANT! If the baud rate is set incorrectly, the
keyboard will not operate. Be sure that the baud
rate is set to the correct value.
To set or change the baud rate:
1. Enter the baud rate (1200, 2400, 4800 or 9600).
2. Press F1 (located to left of the LCD).
No prompts appear on the screen to inform you that
the baud rate has been changed.
Displaying the Firmware Version
If you should experience problems with your
ADTTE, you may need to provide information about
the firmware version.
To display the firmware version:
1. Enter 100, and then press F1. Firmware
information appears on the LCD.
• F represents the Flash version.
• E represents the EEPROM version.
2. Press Clear to refresh the LCD.