Operator`s manual

MEGAPOWER 48 / ADTTE 8200-0170-05, REV. A
OPERATION AND PROGRAMMING REFERENCE GUIDE 14 of 43
Working in Program Mode
STS MON CAM 1234
005 168 +P
STS MON CAM 1234
005 168 -P
Note: The keyboard lock must be disabled to use
this feature. To disable the keyboard lock, see
Unlock/Lock the Keyboard.
When the ADTTE keyboard is in Program mode,
the following MP48 programming tasks can be
performed.
Table 4: Program Mode Tasks
Task Page
Pattern Programming 14
Programming Preset Scenes 15
Programming Monitor Tours 15
Monitor Arming 16
In addition, the following system settings can be
configured via the keyboard.
Table 5: Program Mode System Setup Tasks
Task Page
Resetting the System 17
Setting the Date Format 17
Adjusting Text Display Position 18
Detecting Camera Video Loss 18
Audio Alarm Programming 19
Transferring System Data 19
Unlock/Lock the Keyboard
Before any programming tasks can be performed,
you must first unlock the keyboard by entering the
keyboard lock password. When the ADTTE
keyboard is first installed, the default password
1953 is active. For security purposes, the default
password should be changed. See Changing the
Keyboard Lock Password on page 20.
Unlocking the Keyboard
1. Enter the keyboard lock password.
2. Press Lock (located on the on the right side of
the keypad).
The lower right corner of the LCD displays P,
indicating that programming mode is active.
Locking the Keyboard
When programming tasks are finished, lock the
keyboard.
1. Enter the keyboard lock password.
2. Press Lock.
The lower right corner of the LCD displays L,
indicating that that the keyboard lock is active.
Pattern Programming
Three patterns may be programmed for each
SpeedDome programmable dome. Pattern length
and complexity are limited by two variables:
• The number of available camera commands
• Time
Each time you move the camera in any direction
(with zoom, focus, or iris adjustments), you issue a
command to the camera. The three patterns for a
dome can collectively consist of up to 98 camera
commands.
There is also a pattern time limit. A single pattern
cannot have a duration longer than 400 seconds.
Regardless of the number of commands issued, a
pattern stops recording once the time limit has
elapsed.
Note: Verify that the keyboard is in programming
mode before performing this task. See Unlock/Lock
the Keyboard.
To program a pattern:
1. Press + located to the right of the LCD.
2. Select the camera where the pattern will be
saved.
3. Enter the pattern number (1-3), and press Pattern.
IMPORTANT! With SpeedDome Ultra series
domes, a progress bar displays showing the
remaining number of programming steps
available. The progress bar decreases as the
pattern commands are used. In addition, the
dome moves very slowly during patterns and
cannot be adjusted.
4. Press Prog. Using the Tracker Ball and lens
control keys, maneuver the called camera to
define the pattern.
5. When finished programming the pattern, press
Ack to save.