Operator`s manual
Table Of Contents
- Using MegaPower® 48 Matrix Switcher with ADTTE Keyboard Cont
- About this Guide
- About the MegaPower 48 Matrix Switcher/Controller System
- About the ADTTE Keyboard Controller
- Identifying the ADTTE Operating Mode
- General User Tasks
- Working in Keyboard Lock Mode
- Working in Program Mode
- Changing ADTTE Keyboard Settings
- Working in Menu Mode
- Changing System Settings
- Changing Monitor Settings
- Changing Camera Settings
- Configuring User or Keyboard Settings
- Configuring Switching Settings
- System Partitioning
- Configuring Alarms
- Declarations
MEGAPOWER 48 / ADTTE 8200-0170-05, REV. A
OPERATION AND PROGRAMMING REFERENCE GUIDE 13 of 43
Running Salvos
A salvo is a group of camera scenes that can be
called for simultaneous display on a contiguous
group of monitors. Up to 64 salvos may be
programmed. The Salvo key is located to left of the
numeric keypad beneath the Run and Hold keys.
Figure 15: Salvo key
Run
Hold
Salvo
To call a salvo:
1. Enter the number of the first (lowest numbered)
monitor in the salvo group.
2. Press
(Monitor).
3. Enter the salvo number (1-64).
4. Press Salvo. The salvo will appear on the
appropriate monitor group.
The first monitor of the salvo group displays “HOLD”
on the status line. The remaining monitors in the
salvo group display “SALVO”.
Note: If a salvo is called in response to a system
alarm, the first monitor of the salvo group displays
“ALARM” on the status line. The remaining monitors
in the alarm salvo group display “SALVO”.