Installation Guide
Table Of Contents
- Warning
- Overview
- Tyco Illustra Pro 5MP Thermal Elevated Skin Temperature Detection Camera
- Network Topology
- Network Connection
- Live View
- Search
- Configuration
- Appendix A - Shutdown Procedure
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Technical Specifications
- Appendix D - Manufacturer and Local Contact Information
- Disclaimer and Regulatory
- EMC Information
- End User License Agreement (EULA)
Tyco Illustra Pro 5MP Thermal Elevated Skin Temperature Detection Camera Installation and Configuration
8200-1953-09 A0 97
Manufacturer’s Declaration – Electromagnetic Emissions
The medical system is intended for use in the electromagnetic environment shown below. The user shall
ensure that it is used in such an environment.
Emission test Compliance
Note: The emissions characteristics of this equipment
make it suitable for use in industrial areas and hospitals
(CISPR 11 class A). If used in a residential environment
(for which CISPR 11 class B is normally required) this
equipment might not offer adequate protection to radio-
frequency communication services. The user might
need to take mitigation measure, such as relocating or
re-orienting the equipment.
RF Emissions
CISPR 11
Group 1
RF Emissions
CISPR 11
Class A
Harmonic Emissions
IEC 6100-3-2
Class A
Voltage Fluctuations
and Flicker
IEC 61000-3-3
Complies
Manufacturer’s Declaration – Electromagnetic Immunity
The medical system is suitable for use in a professional healthcare facility environment and not in envir-
onments exceeding immunity test conditions shown below. The user shall ensure that it is used in such an
environment.
Immunity Testy IEC 60601-1-2 Compliance
Electromagnetic Environment Guid-
ance
Electrostatic
Discharge
IEC 61000-4-2
± 8 kV contact
± 2 kV, ± 4 kV, ± 8 kV,
± 15 kV air
Complies
Floors should be wood, concrete,
ceramic tile or anti-static tile. If floors
are covered with synthetic material,
then the relative humidity should be at
least 30%.
Radiated RF EM fields
IEC 61000-4-3
10 V/m 80 MHz – 2,7
GHz 80 % AM at 1
kHz
Complies
Portable and mobile RF com-
munications equipment should follow
the guidance in the table titled “Recom-
mended separation distances between
portable and mobile RF com-
munication equipment and the medical
equipment.”
Field strengths from fixed RF trans-
mitters, as determined by an elec-
tromagnetic site survey should be less
than the compliance level in each fre-
quency range.
Interference may occur in the vicinity